UltraScape SlipBond

Free next working day delivery if ordered by 2pm

UltraScape SlipBond Vertical Stone and Brick Slip Adhesive

UltraScape SlipBond is a flexible cladding adhesive for internal and external use. It consists of blended cements, graded fillers and additives and a high level of redispersible powder polymer. It is specially formulated with extended workability for fixing brick slips and natural stone to a range of substrates including sand/cement render, brick and block work and can be used for wall and floor applications as well as with external and internal wall installation systems.

• Ideal for use in all weathers
• Applied to a thickness of 3mm – 20mm
• Frost resistant
• Suitable for: brick slips and natural stone
• Can be used with external wall installation systems
• Extended workability
• Suitable for underfloor heating
• External / internal use
• 20kg paper bag

Applications

UltraScape SlipBond is a flexible cladding adhesive for external and internal floor and wall applications. It consists of cements, graded fillers and additives and a high level of redispersible powder polymer. It is specially formulated with extended workability for fixing brick slips and natural stone to a range of substrates including sand/cement render, brick and block work and can be used with external wall installation systems.

Technical

UltraScape SlipBond is a fully pre-mixed dry-pack which only requires the addition of water on-site. It can be applied to a thickness of 3mm- 20mm up to 1m2 at a time.

Preparation

The preparation of the surface to be treated is of the greatest importance. Care must be taken to remove all loose material, debris, laitance, grease, paint and efflorescence. The concrete /masonry/ substrate should be thoroughly dampened with water. Any surplus water should be removed prior to commencing application.

Mixing

UltraScape SlipBond should be added slowly to 5.2 litres of clean water per 20kg bag and mixed thoroughly, ideally with a forced action mixer for 3 minutes to give a slump free easily worked adhesive. Once mixed the mortar is immediately ready for use and has a pot life of approximately 2 hours at 20°C. Mix only sufficient material to be used within the pot life, do not remix or re-wet.

Application

Use a trowel to apply a layer of mortar on to the substrate with sufficient force to ensure a good bond. On large format stone it is advisable to back butter the stone unit prior to embedment. Once application of the mortar bed has taken place please ensure that the stone is applied within 25 minutes.

Cleaning
Tools should be cleaned in water immediately after use to remove excess materials.

Quality Assurance
All products are manufactured in a plant whose quality management system is certified / registered as being in conformity with BS EN ISO 9001, ISO 14001 and OHSAS 18001. Our products are guaranteed against defective materials and manufacture and will be replaced or money refunded if the goods do not comply with our promotional literature.

We cannot however accept responsibility arising from the application or use of our products because we have no direct or continuous control over where and how projects are used. All products are sold subject to our conditions of sales, copies of which may be obtained upon request.

To view our extensive range of landscaping products click here